For the installation progress, please click [Suprema Integration with Genetec Security Center] Installation.
Below are the entire steps from adding Suprema devices to authenticate the registered user credential based on the access rule and the cardholders.
Users can add Suprema devices to Suprema Integration with Genetec Security Center and manage the user credential/physical access control to Genetec Security Center.
Please make sure if BioStar 2 Server is not running on the same Suprema Integration Server PC. BioStar 2 Server cannot run on the PC at the same time because of the port conflict.
For the detailed procedure, please visit Suprema website and download the Administrator Guide of Suprema Integration with Genetec Security Center.
1. Run Suprema Integration with Genetec Security Center.
1-1. Enter the ID and password.
The ID is 'deviceadmin', and PIN is the password you set when you installed Suprema Integration with Genetec Security Center.
1-2. Click Search Device and then, register a device. Please note that the device menu administrator would be the same ID/Password of Suprema Integration with Genetec Security Center. In addition, the User ID mode would be set to Alphanumeric automatically once you add the device.
2. Run Genetec Config Tool and confirm if the Suprema device is updated
2.1. Configure door, access schedule, access rule, and cardholders.
3. Add a credential.
4. Check if the user information in Config Tool is to be synchronized to Suprema Integration software.
5. Authenticate the user to the connected Suprema device.